Bevel gear made of die-cast zinc ZnAl4Cu1 module 2.5 16 teeth i=1:1 bore 12mm
| Transmission | 1:1 (16/16) |
|---|---|
| Module | 2,5 |
| No. of Teeth | 16 |
| da [mm] | 43,3 |
| d [mm] | 40 |
| ND [mm] | 26 |
| NL [mm] | 12 |
| L1 [mm] | 23,0 |
| L [mm] | 25,5 |
| b [mm] | 12,3 |
| BH9 [mm] | 12 |
| E [mm] | 36,2 |
| Admissible MD [Ncm] | 230 |
| Weight [g] | 88 |
| Corresponding Counter Wheel [Article-No.] | 35910700 |
Pre zobrazenie cien sa prosím
prihláste
.
Material: Zinc die-cast ZnAI4Cu1.
Shaft angle = 90°. Bores machined. The bevel gears only run as a pair at the stated ratio. In the torque calculation of zinc-die-cast bevel gears only the root strength was considered. Due to the material properties these gears are only to a limited extend suitable for continuous operation. Note for ordering: These gears are sold singulary, not by pair. For a pair of bevel gears, you have to order two matching gears of the same module and ratio. At ratio 1:1, you need two pieces of the same number of teeth. At ratio uneven 1:1, you need two pieces with a different number of teeth of the same ratio.