Spur gear made of polyacetal resin die-cast with hub module 2.5 42 teeth tooth width 17mm outside diameter 110mm
| No. of Teeth | 42 |
|---|---|
| b [mm] | 17 |
| da [mm] | 110 |
| d [mm] | 105 |
| L [mm] | 30 |
| E [mm] | 84 |
| c [mm] | 7 |
| ND [mm] | 30 |
| BH9 [mm] | 16 |
| Admissible MD [Ncm] | 2250 |
| Weight [g] | 126 |
Pre zobrazenie cien sa prosím
prihláste
.
Material: Polyacetal resin die-cast. Bores machined. Pressure angle 20°. With high hardness and low friction coefficient these plastic gears can be used in various set-ups, even under water.
Note Regarding the Machining
Inside these die-cast parts are some cavities caused by production. These parts should therefore not be drilled too deep. With larger bores or when grooving the cavities might become visible. This often does not affect the functionality.